Hi there,

I've been trying to get an RPM gauge working correctly.  It does move up and down the scale correctly however it does not reset back to the same position on Hardware reconnect.

I think I am right in saying that simvim should move the needle all the way to the mechanical limiter upon hardware reconnect however my X27 stepper just make a noise without movement.

Any Ideas?

+5v Input to the Easydriver. MS1 is pulled low (Quarter step mode (I think!))

Thanks
James
Jul 17, 2019 in Stepper Motors by

1 Answer

James,

Please read this page (maybe you have missed something:
http://simvim.com/tech_28byj.html

Vlad
Jul 17, 2019 by
...