Hi dear, I triying to build a yoke and rudder pedals, but, im not sure that this sensor works or not (https://articulo.mercadolibre.com.ar/MLA-622950677-sensor-optico-reflectivo-infrarrojo-cny70-arduino-pic-avr-_JM?quantity=1), maybe need more detail for components needed for this way, also when I configure a Yoke roll analog axys, this parameter move the nose tires too, I need to know why this occurs, because, the nose tires need to move by rudder pedals.
Aug 23, 2019 in Wiring, Powering by

1 Answer

You cannot use these "On/Off - type" sensors.
You need to use a photoresistors as mentioned on this page http://simvim.com/svc_axis.html

To switch the nose wheel steering on/off use the "Nose_Wheel_Steer" parameter in the flight controls section of the configurator.
Vlad
Aug 29, 2019 by
...