Hi, i have a problem.
I'm using simvim with x-plane.
I'm trying to use a servo 360 degrees with an arduino uno connected to the mega 2560. I uploaded correctly the firmware in the uno, i did the configuration to assign port #2 for the servo, everything is well connected, but ... when i try to calibrate in xplane, when i move the cursor, it changes the speed of rotation and the servo don't stop rotating, until i replace the cursor at the starting point.
If you have any idea 

closed with the note: Fixed
ago in Electronic Components to use by

1 Answer

0 votes
 
Best answer

Fecro.

A continuous rotation servo is not a servo, it is simply a motor with a gearbox. A servo needs a pocision sensor to know what angle it is at each moment.
servos with continuous rotation do not work with SIMVIM

Milton Rodriguez.

ago by
0
Thanks a lot for your answer :) it makes sense ^^
...