Having some issues with a nav/com stack that I've created. I have a Dual rotary encoder to control mhz/khz, and when I turn the mhz encoder, it also is calling the XFER command and making the frequencies change back and forth (usually about every two detents, the XFER is triggered). Here is how its all connected:

I have 3 multiplexers, separated into Com/Nav1 Input, Com/Nav2 Input, and Com/Nav output.
Any ideas on how to fix or what might be going on here?
closed with the note: check
Dec 3, 2019 in Wiring, Powering by

1 Answer

 
Best answer

Hi, please read the "Signal flickering issues" section on the Inputs Wiring page.

Dec 4, 2019 by

A 10k resistor did the trick. I sort of remember reading that, but didn't compute in my brain that one input could also be triggering another input because of that, but being on the multiplexer, I think I get how that happens.

Thanks!

...