START / CONFIG
VIDEO / Guides
Ask a Question
WORKING ON ...
Only "Selector_1" is working?
If I try use "Selector" 2, 3 or 4, it does not work, at least in my system.Is this a known problem?
I'm talking about encoder Input with "Selector" mode. In Output mode it looking good. (SimVimCockpit v0.9.58)
to answer this question.
No, any selector should work.
Unfortunately, I can't make "Selector nr> 1" work. In addition, there has been a new problem since yesterday: In the Configurator, you cannot assign any selector as "Toggle Switch" or "Push-Button" or "Series of Buttons". The message "This selector input is already assigned" appears. I checked on 2 computers, different browsers and on a clean "data.cfg" file.
to add a comment.
FMS_INDEX (Init Ref) Zibo not working
Nose wheel tiller - not working?
com1/nav1 in one radio only
Is there a way to desensitize the controls in Simvim?
Is it possible to use Elec_Trim_Up/Dn for stepper control?
Output - Gauges
| Snow Theme by