Hey

In the config for B737 Generator 1 Drive Disconnect (IDG_1_OFF) and 2 are setup as a buttons. However in the plane they are switches. Can I change this somehow?

On the other hand, I have been looking at pedestal for B737 but there is no panel for this, so if I use some generic one will all switches work? Can they be assigned just fine?

Thanks
Krys
1 month ago in General Questions by

1 Answer

Krys,
Please read this.
Vlad

1 month ago by
Thanks, so basically they are no use. I noticed some LED's can't be picked, but I will see if I can get them without table. Could you reply to my other question in regards to the NAV radios for pedestal? Do I just pick any? I am sure I read that they are all working fine with any planes?...

Thanks

Krys
...