"All-in-one radio currently selected" in the "Com/Nav Displays" section of the configurator can not be selected, why?
....
in Configurator by

1 Answer

0 votes
Yes,
because you can assign it  only as "condition" for your display (using its values 0,1,..5).
Also, if you use the LEDs for mode indication (next 6 parameters - "Nav 1 is selected, etc) they can be used as condition.

If needed we can create additional SimVim custom dataref for single multimode display.
Vlad
by
0
Thx. Such display would be nice, like in the Airbus, were the selected aktive and standby mode is shown. Is there any documentation for the use of condition parameter ?
0
We will make it (and video in the "Video Guides" on this page - see the menu at right above.
Vlad
...